Dynojet Data Link Module - OBDII Manuel d'utilisateur télécharger pdf (Page 30)

Data Link Module-OBDII Installation and User Guide

APPENDIX A

Configuration

A-8

ONFIGURING

THE

DJDLM-OBDII

WITH

ATEGORY

5 C

ROSSOVER

ABLE

The category 5 crossover cable ships with the DJDLM-OBDII. This is the fastest data

transfer option available. No configuration is needed to the DJDLM-OBDII when

using the crossover cable; just plug and play.

1 Power the DJDLM-OBDII on in the car.

2 Attach the crossover cable to the Ethernet port on the DJDLM-OBDII.

3 Attach the crossover cable from the DJDLM-OBDII to the dynamometer PC’s

Ethernet port.

ONFIGURING

THE

DJDLM-OBDII

WITH

ATEGORY

5 S

TANDARD

ABLE

This configuration requires a standard category 5 patch cable and a network jack.

You must have a DHCP server configured on your network to run this option. If you

are not sure what a DHCP server is, contact Dynojet Technical Support or a local IT

professional.

1 In the Boot Options window, scroll down to Built-in Internet.

2Select Client then Server from the Network Type drop down menu.

Once connected to your Ethernet network, the DHCP server will assign the

DJDLM-OBDII an IP address and it will be a network member. The DJDLM-OBDII

will then be visible through the network to WinPEP.

Figure A-10: Entering the Built-in Ethernet Parameters

1 2 ... 25 26 27 28 29 30 31 32 33

Pas de commentaire

Dynojet Data Link Module - OBDII Manuel d'utilisateur Page 30