Dynojet Data Link Module - OBDII Manuel d'utilisateur télécharger pdf (Page 25)

DATA LINK MODULE-OBDII BASIC CONFIGURATION

Introduction

Version 4 Data Link Module-OBDII Installation and User Guide

A-3

Category 5 Standard Cable—connects to your wired network with a category 5

standard cable. Refer to “Configuring the DJDLM-OBDII with a Category 5 Standard

Cable” on page A-8 for more information.

Figure A-4: Category 5 Standard Cable Configuration

ONNECTING

THE

DJDLM-OBDII

Once unpacked, a direct connection via a crossover cable must be made.

1 Plug the DJDLM-OBDII into a vehicle for a power source. Turn the vehicle’s key to

the ON position. The engine may need to be running on some vehicles in order to

power the DJDLM-OBDII.

2 Connect the crossover cable to the DJDLM-OBDII and to your PC.

3 Turn on the DJDLM-OBDII power.

4 Open Internet Explorer.

5 In the address bar, type 192.168.0.101. Do not type anything else.

6Press Enter.

You will see the following window when successfully connected.

Figure A-5: DJDLM-OBDII Successfully Connected

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

Pas de commentaire

Dynojet Data Link Module - OBDII Manuel d'utilisateur Page 25