Dynojet Spring Applied Air Release (SAAR) Brake Assembly Manuel d'utilisateur télécharger pdf (Page 10)

Spring Applied Air Release (SAAR) Brake Assembly Installation

SPRING APPLIED AIR RELEASE (SAAR) BRAKE ASSEMBLY INSTALLATION

The Hydraulic Brake Assembly

5 On standard dynos the brake control wiring is connected to the breakout board.

The breakout board is located on the dyno as shown in Figure 3.

Disconnect the two wires from the wiring block labeled BRAKE on the Breakout

board, as shown in Figure 3. These two wires connect the brake solenoid. It

should now be disconnected.

Note: If you are installing the upgrade on a four-wheel drive dyno, see “Four

Wheel Drive Dynos” on page 20 for the connections of the brake solenoid to the

movement board.

Never operate the dynamometer when the brake is not functioning.

Figure 3: Disconnect the Hydraulic Brake Control Wiring from the Breakout Board

AD167

disconnect

brake

assembly

wiring

BRAKE

breakout

board

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Pas de commentaire

Dynojet Spring Applied Air Release (SAAR) Brake Assembly Manuel d'utilisateur Page 10