Dynojet Analog Module Manuel d'utilisateur télécharger pdf (Page 14)

Analog Module Installation and User Guide

CHAPTER 2

Analog Channel Configuration

2-2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ANALOG CHANNEL CONFIGURATION

You can configure up to four different analog channels. Use the following instructions

to configure the analog channel(s).

CONFIGURING THE ANALOG CHANNEL(S)

1 Verify you are in the MakeRun screen.

2 Verify you are connected to the dyno electronics.

Note: You must be connected to the dyno electronics and the Analog Module

must be installed for the analog channels to be available.

Note: For more information on connecting to the dyno electronics, refer to the

WinPEP 7 User Guide (on your WinPEP CD or at

www.dynojet.com/manuals.shtml) or the WinPEP 7 Online Help.

3Select Too l s



MakeRun Options



Analog Configuration.

4 Select the desired analog channel tab.

5Click the Enable logging on this channel check box.

6Click Sensor Helper.

Figure 2-1: Analog Configuration Window—Select Desired Channel

analog channel tabs

sensor helper

check box

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Dynojet Analog Module Manuel d'utilisateur Page 14